What are Blu-ray and DVD region codes, country codes, multi-region or zone locks? Read DVD Player region codes and Blu-ray region codes.
| DVD Player | Hacks | Updated | Add |
| Denon ADV-700 | 1 user region code comments |
April 05, 2005 | Post region code/hack comment |
 Region code hack posted by marc, April 05 2005: | |||
Here is a hack I found on the net. It works perfectly but you have to write a file on a CR-R. I can send you the file by email: mgibeault@post.com ADV-700 SYSTEM, Updating Procedure of the DVD Software: 1) The updating procedure of the System (ESS Memory of the DVD). Turn the Power Switch ON. Press OPEN/CLOSE Button to open the Tray. Then, put the CD-R/CD-RW Disc for updating on the Tray and play it. The FL Display shows "Start P. Load", and the writing operation is automatically carried out successively. The display shows SYS.VER.0000 (DVD ESS MEMORY) and the Tray opens. Take the CD-R/CD-RW Disc out from the Tray. After opening the Tray, set the unit to STANDBY mode, and press OPEN/CLOSE Button to close the Tray. Then, disconnect the AC Power Cord from the AC outlet. • Note: Please do not turn the Power off until the writing operation completes. 2) Confirmation procedure of the Version of each software. While holding STATUS and OPEN/CLOSE Buttons down together, connect the AC cord to the AC outlet. The Power indicator turns into Red and the unit enters at Standby mode. Turn the Power switch on so that the Red LED indication changes into Orange. Press STATUS Button. The FL Display shows: • The Version of the System Microprocessor. • The Version of the DRIVE Microprocessor of the DVD Mechanism. • The Version of the VIDEO DRIVE Microprocessor. • Region Code.(region: 1,2,3) After confirming the versions, disconnect the AC cord from the AC outlet. The indications appear according to the above sequence. Therefore, please refer to the above. 3) Initializing procedure of the SYSTEM and DVD (Initialization) a) To initialize the System and DVD at the same time. Disconnect the AC Cord from the AC outlet. While holding the PLAY and STOP Buttons down together, connect the AC Cord to the AC outlet. When the Button is pressed continuously, the FL Display flashes totally. When the Button is released, the FL Display indicates "INITIALIZE". b) To initialize the DVD only: After the Power is turned on, press SKIP REV Button for longer than three seconds. "INITIALIZE" appears and the initialization completes. | |||
| 1 DVD Hack hits, Showing 1 to 1 DVD Hacks |
New hacks = New region code/hack comments since your last visit. Visit our sponsors! Try DVDFab and backup Blu-rays!